Storage engines
Every storage system VERTEX makes, each with its own engine on the same core: set it up, watch it change live in 3D, download it. Every part prints without supports, and the wall systems have a fit test to print first.
Licence and credits
Plan a whole wall
Honest about the sizes
openGrid parts follow the published openGrid interface (28 mm grid, 6.8 mm Full and 4.0 mm Lite boards, octagonal cells with a 25.0 mm land and 26.4 mm groove). openGrid is by David D, shared under CC BY 4.0; VERTEX's parts are compatible, not official. Printers vary, so print the fit test and set the corner clearance from it. Board connectors and the pockets they sit in, and the Multiconnect head, follow the openGrid and Multiconnect interfaces as the community's open-source tools build them (QuackWorks by Andy Levesque); VERTEX's geometry is its own. Multiboard's licence keeps its parts to MultiBuild's own tools, so there's no Multiboard generator here.
Pegboard comes in two common sizes: 1 inch spacing with ¼ inch holes (the US hardboard kind) and 25 mm metric. Pick yours above, then measure your holes and board and change the numbers if they differ. French cleats use a 45° slope; the rail defaults to 12 mm thick, and the gap setting keeps the accessory's cleat from binding on it.