Skip to content
VERTEX · Resin printing

Resin, done properly.

The other kind of printing: liquid resin cured by light, a layer at a time, for detail a nozzle can't reach. Here: every resin family and what it's for, the printers, starting points for settings, supports, and the safety rules that keep it a hobby.

Before the first print

Resin is a skin sensitiser and the wash liquid is flammable. None of this is hard; all of it is every time.

Starting points

Pick your printer and resin. These are ranges from the makers' published figures, adjusted for the printer's light. A calibration print settles the exposure; nothing replaces it.

Found your numbers? Share them in the Recipe Book so the next person starts closer.

Every resin, and what it's for

Exposure is for a monochrome LCD at 0.05 mm layers. Tough is compared with standard resin (×1); heat is roughly where a cured part softens.

Resin printers

Build volume, pixel size and the light source. Smaller pixels mean finer detail, not better prints on their own. Add yours to your Loadout.

Supports and orientation

Most resin failures are a part pulling off its supports or off the film. These six rules stop nearly all of them.

Holes and pegs come out small on resin too: Material Memory learns the offset from one measurement, per resin.