Skip to content
Strength check

Will it hold?

Upload a part, say what it has to hold and how it’s fixed, and see where it would bend or break, in colour, with why and what to change. Like the stress test in CAD programs, in plain words. Your file stays in your browser.

1 Your part

No file yet

Upload it lying the way you’ll print it: the check reads the layers as flat on the bed.

2 What is it for?

3 Check it

Choose a file or try the example first.

How the check works

  1. Cubes. The part is cut into a few thousand small cubes. Cubes on the outside are the solid walls; cubes inside are as strong as your infill.
  2. Forces. The side against the wall is held still, the weight pulls where you tapped, and the forces are worked out through every cube: the same method CAD programs use (finite elements), simplified.
  3. Two ways to break. Each cube is compared with what the plastic can take along the layers, and across them. Layers bond at roughly half the strength, which is why most prints snap along a layer line.
  4. Colours. Green is working easily, yellow is working hard, red is over its limit. The white box marks the weakest spot.

It’s an estimate to compare designs and find weak spots early, not a guarantee. Real prints vary with the printer, the settings, the spool and the room. Test a print before you trust it with anything heavy, and never with anything over people.