Every preset now prints without supports
Check supports was run on all 53 Gridfinity and Skådis presets. It found problems, and every one is now fixed:
- Lite bins have a thin cross rib inside each hollow foot, so the floor never bridges more than about 20 mm.
- Label shelves are never flatter than 42° underneath. On shallow bins the shelf gets shallower instead. The angle slider now stops at 42°.
- Split lite baseplates keep the lattice solid around each clip socket, with a thin cap over it, and the border follows the rounded outer corners.
- Skådis:
- The tabs are now separate clips. A tab's lip hangs down behind the board, and nothing that hangs down can print attached without supports, whichever way the part lies.
- Each accessory gets a hole in its back plate and prints with a sheet of small clips, printed flat so they're strong along their length. Push a clip through each hole from the front, then hang the part as usual.
- Shelves, trays, tool holders, the Gridfinity shelf and the double hook now print standing up, floor on the bed. Single hooks still print on their side.
- Presets no longer leak into each other. Picking "Deep lite" used to turn every bin you picked after it lite.