Skip to the forum
VERTEXForum
The Changelog

0.9.1: Every preset now prints without supports

Every preset now prints without supports

Check supports was run on all 53 Gridfinity and Skådis presets. It found problems, and every one is now fixed:

  • Lite bins have a thin cross rib inside each hollow foot, so the floor never bridges more than about 20 mm.
  • Label shelves are never flatter than 42° underneath. On shallow bins the shelf gets shallower instead. The angle slider now stops at 42°.
  • Split lite baseplates keep the lattice solid around each clip socket, with a thin cap over it, and the border follows the rounded outer corners.
  • Skådis:
  • The tabs are now separate clips. A tab's lip hangs down behind the board, and nothing that hangs down can print attached without supports, whichever way the part lies.
  • Each accessory gets a hole in its back plate and prints with a sheet of small clips, printed flat so they're strong along their length. Push a clip through each hole from the front, then hang the part as usual.
  • Shelves, trays, tool holders, the Gridfinity shelf and the double hook now print standing up, floor on the bed. Single hooks still print on their side.
  • Presets no longer leak into each other. Picking "Deep lite" used to turn every bin you picked after it lite.

0.9.1 · 27 September 2026 on the changelog