New: the Paddock pod takes drop-in modules

- The Paddock desk pod is modular now. Its width is split into bays (one per 30 mm, less one), and each bay takes a module that drops in through the open front and lifts straight out again.
- Eleven modules to start:
- Pen cup, markers and highlighters, screwdrivers and tweezers
- SD cards, microSD cards, ¼" hex bits
- AA and AAA batteries
- a phone stand (two bays wide, leaning back 20°)
- an open cup and a low tray for keys and coins
- Pockets are honeycomb, so they hold the most for the least plastic. A small stop on the floor keeps modules from sliding back.
- New presets show them off: Paddock maker pod, Paddock phone dock and Paddock workbench pod.
New: side panels that clip on and off
- Every pod's side panels now snap on. Short walls round the inside locate the panel, flexible tabs click over a small bead inside the sleeve, and a groove round the edge gives you a fingertip to pull it off again.
- Pods join into a row with open sides: choose Open on the right for the end of a row or Open both sides for the middle. The two floors lock together underneath with link keys.
New: proof that it prints without supports

- Check supports, next to Download in every generator, slices each part the way your slicer does, 0.4 mm at a time, standing the way it prints. Then it shows, part by part, whether anything would print in mid-air.
- Every MotiveMorph part now passes: pods in all three Auras, modules, side panels, dividers, faceplates, clips, bins, shelves, hooks, tiles, tool trays, pins and keys, with every lattice pattern and mount. This is now checked automatically on every update.
- Changes that made it possible:
- The rails inside the pod are carried by 45° wedges.
- Dividers sit in 45° grooves.
- The Studio's front is open right across instead of having a long lintel.
- The Galley's shelf runs full width.
- Holes in upright walls have pointed (teardrop) tops.
- Honeycomb and slot lattices are shaped to print standing up.
- The tile's screw holes have their own bosses.
- Twist-lock pins now print lying on their side. Every layer runs the length of the pin, so they're much stronger, and the head is a wing that's easier to turn.
- Material too: nothing is solid that doesn't need to be. Modules use thin-walled honeycomb, and the lattices skip the ends where the clips are.
Everything in this update · Tell us what you think in the forum